Drop End Tolerance Off

[BoxAndGo]

The styles with drop ends seem to be cutting to short. I can't find the setting for this.

[Support]

Hi,

Please make certain you have updated your Styles file with the most recent update. December 2009.

The location for setting your drop end tolerance is located in the SetUp module > Construction. For each category of style there is a Rules tab. Adjust the "End Panel to floor distance on a Drop Panel".

Some styles implement a "Drop End" or "Drop Panel" where two panels extend past the skids to or near the floor. This is the distance from the floor (or top of rub strips if used) that the panel extends down to.